blob: d4c8319fa231fe92b63eeecf1179e60ab30998fc (
plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
|
The following steps assume at least the GNUnet and Gtk+ dependencies are installed.
First, unpack the gnunet-gtk tarball and change into the resulting directory.
Then, use the following commands to build and install gnunet-gtk:
.. code-block:: console
$ ./configure [--prefix=$PFX] \
[--with-gnunet=$GNUNETPFX]
$ # Each dependency can be fetched from non standard locations via
$ # the '--with-<LIBNAME>' option. See './configure --help'.
$ make
# make install
It is highly recommended to use the same prefix ($PFX) for gnunet-gtk that was
used for GNUnet ($GNUNETPFX). If you did not specify a prefix, gnunet-gtk
will be installed to ``/usr/local``, which requires you to run the last step
as ``root``.
You have to specify ``--with-gnunet=/usr/local`` if you installed
GNUnet to ``/usr/local`` in the previous steps.
Depending on the prefixes you specified for the installation and the
distribution you are using, you may have to edit ``/etc/ld.so.conf``, adding
lines for ``$GNUNETPFX/lib/`` and ``$PFX/lib/`` (replace the prefixes with the
actual paths you used). Afterwards, you should run ``ldconfig``. Without this
step, it is possible that the linker may not find the installed libraries and
launching gnunet-gtk would then fail.
|
