diff options
Diffstat (limited to 'doc/sphinx/frags/installing-taler-merchant.rst')
-rw-r--r-- | doc/sphinx/frags/installing-taler-merchant.rst | 34 |
1 files changed, 34 insertions, 0 deletions
diff --git a/doc/sphinx/frags/installing-taler-merchant.rst b/doc/sphinx/frags/installing-taler-merchant.rst new file mode 100644 index 0000000..249d5d7 --- /dev/null +++ b/doc/sphinx/frags/installing-taler-merchant.rst @@ -0,0 +1,34 @@ +GNU Taler merchant has these additional dependencies: + +- libqrencode >= 4.0.0 + +The following steps assume all dependencies are installed. + +First, unpack the GNU Taler merchant tarball and change into +the resulting directory. +Then, use the following commands to build and install the merchant backend: + +.. code-block:: console + + $ ./configure [--prefix=PFX] \ + [--with-gnunet=GNUNETPFX] \ + [--with-exchange=EXCHANGEPFX] + $ # Each dependency can be fetched from non standard locations via + $ # the '--with-<LIBNAME>' option. See './configure --help'. + $ make + # make install + +If you did not specify a prefix, the exchange will install to +``/usr/local``, which requires you to run the last step as ``root``. + +You have to specify ``--with-exchange=/usr/local`` and/or +``--with-gnunet=/usr/local`` if you installed the exchange and/or +GNUnet to ``/usr/local`` in the previous steps. + +Depending on the prefixes you specified for the installation and the +distribution you are using, you may have to edit ``/etc/ld.so.conf``, adding +lines for ``GNUNETPFX/lib/`` and ``EXCHANGEPFX/lib/`` and ``PFX/lib/`` +(replace the prefixes with the actual paths you used). Afterwards, you should +run ``ldconfig``. Without this step, it is possible that the linker may not +find the installed libraries and launching the Taler merchant backend would +then fail. |